RM3660EC
_59
Vehicle Exterior
_080784
LIGHTING (EXT)
_0393171
AUTOMATIC HIGH BEAM MAIN SWITCH
G
LIGHTING (EXT) AUTOMATIC HIGH BEAM MAIN SWITCH INSPECTION
PROCEDURE
84153
1.INSPECT AUTO HIGH BEAM SWITCH
1.573,1.865 1.656,1.365
true
1.281,1.865 1.448,1.365
true
1,1.865 1.25,1.365
true
1.917,1.865 1.833,1.365
true
2.219,1.865 2.052,1.365
true
2.5,1.865 2.25,1.365
true
0.167,0.177 0.479,0.333
0.313,0.156
10
false
*a
0.75,1.865 1.365,2.063
0.615,0.198
10
false
ILL+
2.5,1.865 3.115,2.063
0.615,0.198
10
false
ILL-
1.125,1.865 1.438,2.063
0.313,0.198
10
false
+B
1.427,1.865 2.042,2.063
0.615,0.198
10
false
AZBI
1.833,1.865 2.448,2.063
0.615,0.198
10
false
IND+
2.229,1.865 2.385,2.063
0.156,0.198
10
false
E
| *a | Component without harness connected
(Auto High Beam Switch) |
a.
Resistance Check
i.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 5 (+B) - 2 (E) Auto high beam switch off 10 kΩ or higher Auto high beam switch on Below 1 Ω
If the result is not as specified, replace the auto high beam switch.
b.
Illumination Inspection
i.
Apply auxiliary battery voltage to the auto high beam switch and check that the switch illuminates.
- OK:
Switch Illumination Measurement Condition Condition Specified Condition Auxiliary battery positive (+) → Terminal 6 (ILL+)
Auxiliary battery negative (-) → Terminal 1 (ILL-)Always Switch illumination illuminates
- OK:
Switch Indicator Measurement Condition Condition Specified Condition Auxiliary battery positive (+) → Terminal 3 (IND+)
Auxiliary battery negative (-) → Terminal 4 (AZBI)Always Switch indicator illuminates
If the result is not as specified, replace the auto high beam switch.