RM3660EC _51 Engine / Hybrid System _080778 8ZR-FXE ENGINE CONTROL _0392136 CAMSHAFT POSITION SENSOR A

8ZR-FXE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11101E 1.INSTALL CAMSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

NOTICE:

If reusing a camshaft position sensor, check the O-ring.



b.
A394202C03
0.927,0.948 0.635,0.948 true 1.521,0.583 1.75,0.771 0.229,0.188 10 true *a 0.406,0.865 0.635,1.052 0.229,0.188 10 true *b
*a Torque Wrench Fulcrum Length
*b 10 mm Union Nut Wrench


Temporarily install the camshaft position sensor to the cylinder head cover sub-assembly with a new bolt.

NOTICE:
·

Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.

·

If a camshaft position sensor has been struck or dropped, replace it.




c.

Using a 10 mm union nut wrench, tighten the bolt.

Torque:
Specified tightening torque : 10 N*m (102 kgf*cm, 7 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a 10 mm union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):

8.8 N*m (90 kgf*cm, 78 in.*lbf)




d.

Connect the camshaft position sensor connector.


e.

Connect the No. 1 fuel vapor feed hose to the fuel vapor feed pipe.