DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body or Entry&Start / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Communication D-Door Motor | Connection status between power window regulator motor assembly LH*1 or RH*2 and main body ECU (multiplex network body ECU) | OK or STOP | OK: Connected
STOP: Not connected |
DTC is output if an error occurs in LIN communication. |
| Communication P-Door Motor | Connection status between power window regulator motor assembly RH*1 or LH*2 and main body ECU (multiplex network body ECU) | OK or STOP | OK: Connected
STOP: Not connected |
DTC is output if an error occurs in LIN communication. |
| Communication Master SW | Connection status between multiplex network master switch assembly and main body ECU (multiplex network body ECU) | OK or STOP | OK: Connected
STOP: Not connected |
DTC is output if an error occurs in LIN communication. |
| The Number of DTC | Number of DTCs | 0 to 255 | Number of stored DTCs | - |
*1: for LHD
*2: for RHD