PRECAUTION FOR BULB REPLACEMENT
Always prepare a new bulb for immediate replacement. While replacing a bulb, the lens may attract dust and moisture if removed from the vehicle for a long time.
Always replace a bulb with another bulb of the same wattage.
If only replacing the bulb on one side, differences in brightness and lighting color between the right and left sides may occur.
Securely install the socket after bulb replacement. The lens may become cloudy or the light cavity may fill with water through gaps around the socket if the socket is not installed securely.
PRECAUTION FOR HEADLIGHT BEAM AXIS ADJUSTMENT
Do not use the cover for 3 minutes or more when the headlight is illuminated.
The headlight outer lens is made of synthetic resin, which may melt or be damaged due to excessive heat.
PRECAUTIONS FOR AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM
If any of the following are performed, it is necessary to initialize the headlight ECU sub-assembly LH.
Replacement of the rear height control sensor sub-assembly LH
Removal/installation of the rear height control sensor sub-assembly LH
Work that changes the vehicle height such as replacement of suspension components
PRECAUTION WHEN REPLACING HEADLIGHT ECU SUB-ASSEMBLY LH
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
When replacing the headlight ECU sub-assembly LH, always replace it with a new one. If a headlight ECU sub-assembly LH which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
PRECAUTION FOR FRONT CAMERA SYSTEM (w/ Automatic High Beam System)