RM35X0E _56 Audio / Visual / Telematics _079315 PARK ASSIST / MONITORING _0396274 PANORAMIC VIEW MONITOR SYSTEM C

PARK ASSIST / MONITORING PANORAMIC VIEW MONITOR SYSTEM C1697 Camera Position Adjustment Incomplete

DESCRIPTION

This DTC is stored when the parking assist ECU judges that the camera initial setting has not been memorized (camera view adjustment is incomplete).

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
C1697	Camera Position Adjustment Incomplete	Camera initial setting has not been memorized	· Camera view adjustment · Parking assist ECU

NOTICE:: ·

When the "!" mark is displayed on the multi-display after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION201906,999999,_56,_079315,_0396274,RM100000001IGR3,

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION201906,999999,_56,_079315,_0396274,RM100000001IGR4,

1.ADJUST SETTINGS (CAMERA VIEW ADJUSTMENT)

Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.

Refer to camera view adjustment.

Result:

Proceed to
NEXT

2.CHECK FOR DTC

Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs: 50002 353

Check for DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes: 50001 353

HINT:: ·

If DTC C1697 is output, perform the camera view adjustment again.

·

If DTC C1697 is still output after performing the camera view adjustment 3 times, replace the parking assist ECU.

Result:

Proceed to
OK
NG

END (CAMERA VIEW ADJUSTMENT WAS DEFECTIVE)

REPLACE PARKING ASSIST ECU