DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Key Unlock Warning SW | Un-lock warning switch signal | ON or OFF | ON: Key in ignition key cylinder
OFF: No key in ignition key cylinder |
- |
| ACC SW | Ignition switch ACC signal | ON or OFF | OFF: Ignition switch off
ON: Ignition switch ACC |
"ON" is also displayed for this item when the ignition switch is ON. |
| IG SW | Ignition switch ON signal | ON or OFF | OFF: Ignition switch off
ON: Ignition switch ON |
"OFF" is also displayed for this item when the ignition switch is ACC. |
| FR Door Courtesy SW | Front door courtesy light switch RH signal*1 | ON or OFF | ON: Front door RH open
OFF: Front door RH closed |
- |
| FL Door Courtesy SW | Front door courtesy light switch LH signal*2 | ON or OFF | ON: Front door LH open
OFF: Front door LH closed |
- |
*1: for RHD
*2: for LHD
ACTIVE TEST
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Buzzer Operation (800Hz, Vol L, W/ Damping) | Combination meter buzzer
·
Frequency: 800Hz ·
Volume: Large ·
Fading tone |
ON | - |