DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / SRS Airbag / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Driver Seat Position | Driver Seat Position | Forward, Backward or Fail
Backward: Seat position is backward Fail: Failure is detected |
Forward, Backward | - |
| Display Type Information | Display type information | LR: Display is indicated by LH / RH
DP: Display is indicated by Driver Side / Passenger Side |
LR | - |
| Right Side 2nd Seat Buckle SW | Rear seat belt RH | Unset: Rear seat belt RH not fastened
Set: Rear seat belt RH fastened NG: Data is not determined |
Unset/Set | - |
| Left Side 2nd Seat Buckle SW | Rear seat belt LH | Unset: Rear seat belt LH not fastened
Set: Rear seat belt LH fastened NG: Data is not determined |
Unset/Set | - |
| Number of Past DTC | Number of Past DTCs | Min.: 0, Max.: 255 | Number of stored DTCs displayed | - |