DATA LIST
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / Lane Control / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Total Distance Traveled | - | - | - | Cannot be used |
| Total Distance Traveled - Unit | - | - | - | Cannot be used |
| LDA Control | Lane control system control status | Prohibit or Permit | Prohibit: Control prohibited
Permit: Control permitted |
- |
| Turn Switch (Right) | Right turn signal switch status | OFF or ON | ON: Right turn signal switch on
OFF: Right turn signal switch off |
- |
| Turn Switch (Left) | Left turn signal switch status | OFF or ON | ON: Left turn signal switch on
OFF: Left turn signal switch off |
- |
| Vehicle Information (2WD/4WD) | - | - | - | Cannot be used |
| Vehicle Information (Conv/HV) | - | - | - | Cannot be used |
ACTIVE TEST
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / Lane Control / Active Test.
According to the display on the GTS, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Meter Buzzer | Sounds the meter buzzer | Start or Stop | Perform this Active Test with the vehicle is stopped and ignition switch to ON. |