DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / PPS / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Steering Angle Velocity (PPS) | Steering angle speed | Min.: 0 deg/s
Max.: 6000 deg/s |
Value changes in proportion to steering effort: The engine is running and the steering wheel is being turned | - |
| Steering Angle (PPS) | Steering angle | Min.: -3072.0 deg
Max.: 3070.5 deg |
The engine is running and the steering wheel is being turned
·
Left turn: Increases ·
Right turn: Decreases |
- |
| Solenoid Actual Current (PPS) | Solenoid Current | Min.: 0 mA
Max.: 1000 mA |
200 to 950 mA: The engine is running and the steering wheel is being turned | - |
| IG Power Supply (PPS) | ECU power source voltage | Min.: 0.0 V
Max.: 25.5 V |
11 to 14 V: The ignition switch is ON | - |
| Vehicle Speed (PPS) | Vehicle speed from meter | Min.: 0.00 km/h (0.00 mph)
Max.: 327.67 km/h (203.61 mph) |
0 km/h (0 mph): The vehicle is stopped
No large fluctuation: The vehicle is driven at a constant speed |
- |
| Engine Revolution (PPS) | Engine speed | Min.: 0 rpm
Max.: 12800 rpm |
No large fluctuation: The engine is running at a constant speed | - |
| MAP Information (PPS) | Number of DTCs | Min.: 0
Max.: 255 |
0 | - |