DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ASL SW | Speed limiter switch signal | ON or OFF | OFF: Speed limiter switch off
ON: Speed limiter switch on |
- |
| ASL Vehicle Speed | Vehicle speed | Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) | Actual vehicle speed displayed | - |
| ASL Memory Vehicle Speed | Vehicle speed | Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) | Vehicle speed stored in memory | - |
| ASL Request Limit Driving Force | Speed limiter request limit driving force | Min.: -10.00 kN, Max.: 9.92 kN | - | - |
| ASL Request Gear Position | Transaxle gear request signal | None to 255 Gear | Required transaxle gear | - |
| TRC/VSC OFF Indicator | TRC/VSC OFF indicator signal | ON or OFF | OFF: TRC/VSC OFF indicator not illuminated
ON: TRC/VSC OFF indicator illuminated |
- |
| ASL Cancel History (Lost Communication with Brake System) | Speed limiter cancel history (lost communication with brake system) | ON or OFF | OFF: Speed limiter cancel history (lost communication with brake system) does not exist
ON: Speed limiter cancel history (lost communication with brake system) exists |
- |
| ASL Cancel History (Speed Sensor Malfunction) | Speed limiter cancel history (speed sensor malfunction) | ON or OFF | OFF: Speed limiter cancel history (speed sensor malfunction) does not exist
ON: Speed limiter cancel history (speed sensor malfunction) exists |
- |
| Kickdown Switch | Kickdown Switch signal | ON or OFF | OFF: Accelerator pedal released
ON: Accelerator pedal fully depressed |
- |
| ASL Limiting Driving Force | ASL limiting driving force operation condition | Inactive or Active | Active: ASL limiting driving force is operating
Inactive: ASL limiting driving force is not operating |
- |
| ASL Ready | Speed limit standby condition | ON or OFF | OFF: Speed limiter switch off
ON: Speed limiter switch on |
- |