RM35X0E _51 Engine / Hybrid System _078720 7GR-FKS ENGINE CONTROL _0381924 ENGINE COOLANT TEMPERATURE SENSOR A

7GR-FKS ENGINE CONTROL ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Replacement of engine coolant temperature sensor	Inspection after repair	· Poor idle, etc. · Engine start function, etc.	(201902,999999,_51,_078720,_0381907,RM100000001G2VV,)

PROCEDURE

Hide Display 17190 1.REMOVE INTAKE AIR SURGE TANK ASSEMBLY

Click hereEngine / Hybrid System>7GR-FKS (INTAKE / EXHAUST)>INTAKE MANIFOLD>REMOVAL201902,202310,_51,_079308,_0385725,RM100000001GNNS_01_0175,202310,999999,_51,_079308,_0385725,RM100000002G5DL_01_0175,

Hide Display 89422 2.REMOVE E.F.I. ENGINE COOLANT TEMPERATURE SENSOR

Disconnect the E.F.I. engine coolant temperature sensor connector.

Remove the clip and E.F.I. engine coolant temperature sensor from the rear water by-pass joint.