RM35X0E _51 Engine / Hybrid System _078720 7GR-FKS ENGINE CONTROL _0381909 CAMSHAFT OIL CONTROL VALVE(for Intake Side of Bank 1) A

7GR-FKS ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE(for Intake Side of Bank 1)  INSTALLATION  


PROCEDURE

Hide 2.INSTALL CAMSHAFT TIMING GEAR BOLT

a.
A352538

Apply engine oil to the areas of the camshaft timing gear bolt shown in the illustration.


b.

Temporarily install the camshaft timing gear bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the camshaft timing gear bolt has been struck or dropped, replace it.

·

If there is any abnormal resistance when temporarily installing the camshaft timing gear bolt, loosen it and make sure that the No. 1 cylinder is at TDC/compression, and then temporarily install the camshaft timing gear bolt again.



HINT:

Make sure that the flange part of the camshaft timing gear bolt contacts the entire circumference of the camshaft timing gear assembly.



c.

Loosen the camshaft timing gear bolt 60 to 180°.


d.

Turn the crankshaft pulley assembly counterclockwise approximately 30 to 90°.


e.
A443181N01
1.896,1.781 2.479,1.781 true 2.125,1.76 2.125,1.49 true 2.531,1.698 2.948,1.906 0.417,0.208 10 true SST

Using SST, hold the crankshaft pulley assembly.

SST
09213-54015  (91651-60855)
09330-00021  


f.

Tighten the camshaft timing gear bolt.

Torque:
95 N*m (969 kgf*cm, 70 ft.*lbf)

NOTICE:

Do not use an impact wrench.



Hide 15370 3.INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side of Bank 1)

Click hereEngine / Hybrid System>7GR-FKS (ENGINE CONTROL)>CAMSHAFT OIL CONTROL SOLENOID>INSTALLATION