The main relay is built into the electric brake booster (brake booster with master cylinder assembly).
When the electric brake booster (brake booster with master cylinder assembly) detects a malfunction in a circuit necessary for main relay to operate, or in the main relay itself, this DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | DTC Output from | Note |
|---|---|---|---|---|---|---|
| C145D49 | Electronic Brake Booster Motor "A" Power Supply Circuit "A" Internal Electronic Failure | Main relay inside electric brake booster (brake booster with master cylinder assembly) stuck ON detected. | Electric brake booster (brake booster with master cylinder assembly) | Comes on | Brake Booster | ·
SAE Code: C145D (Case 2) ·
Output ECU: Electric brake booster (brake booster with master cylinder assembly) |
| C145D71 | Electronic Brake Booster Motor "A" Power Supply Circuit "A" Actuator Stuck | Main relay inside electric brake booster (brake booster with master cylinder assembly) power source circuit condition detected. | Electric brake booster (brake booster with master cylinder assembly) | Comes on | Brake Booster | ·
SAE Code: C145D (Case 1) ·
Output ECU: Electric brake booster (brake booster with master cylinder assembly) |
When performing the normal judgment procedure, make sure that the driver door is closed and is not opened at any time during the procedure.
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
When clearing the permanent DTCs, refer to the "CLEAR PERMANENT DTC" procedure.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off.
Turn the ignition switch to ON (READY) and turn the GTS on.
Wait for 1 second or more. [*]
[*]: Normal judgment procedure.
The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.
Enter the following menus: Chassis / Brake Booster / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE, perform driving pattern again.
| Proceed to |
|---|
| NEXT |
NEXT