When the motor rotation angle sensor inside the electric brake booster (brake booster with master cylinder assembly) meets the detection conditions, this DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | DTC Output from | Note |
|---|---|---|---|---|---|---|
| C129A2B | Electronic Brake Booster Motor "A" Position Sensor Signal Cross Coupled | Motor rotation angle sensor (brake booster with master cylinder assembly) detected outside of operating range. | Electric brake booster (brake booster with master cylinder assembly) | Comes on | Brake Booster | ·
SAE Code: C129B (Case 1) ·
Output ECU: Electric brake booster (brake booster with master cylinder assembly) |
| C129A84 | Electronic Brake Booster Motor "A" Position Sensor Signal Below Allowable Range | Motor rotation angle sensor (brake booster with master cylinder assembly) detected outside of operating range. | Electric brake booster (brake booster with master cylinder assembly) | Comes on | Brake Booster | ·
SAE Code: C129B (Case 3) ·
Output ECU: Electric brake booster (brake booster with master cylinder assembly) |
| C129A85 | Electronic Brake Booster Motor "A" Position Sensor Signal Above Allowable Range | Motor rotation angle sensor (brake booster with master cylinder assembly) detected outside of operating range. | Electric brake booster (brake booster with master cylinder assembly) | Comes on | Brake Booster | ·
SAE Code: C129B (Case 2) ·
Output ECU: Electric brake booster (brake booster with master cylinder assembly) |
| C135A1C | Electronic Brake Booster Motor "A" Position Sensor Circuit "A" Circuit Voltage Out of Range | ·
Motor rotation angle sensor (brake booster with master cylinder assembly) voltage value detected is higher than operating range. ·
Motor rotation angle sensor (brake booster with master cylinder assembly) voltage value exceeds operating range. |
Electric brake booster (brake booster with master cylinder assembly) | Comes on | Brake Booster | ·
SAE Code: C135B (Case 1 and 2) ·
Output ECU: Electric brake booster (brake booster with master cylinder assembly) |
| C136A1C | Electronic Brake Booster Motor "A" Position Sensor Circuit "B" Circuit Voltage Out of Range | ·
Motor rotation angle sensor (brake booster with master cylinder assembly) voltage value detected is higher than operating range. ·
Motor rotation angle sensor (brake booster with master cylinder assembly) voltage value exceeds operating range. |
Electric brake booster (brake booster with master cylinder assembly) | Comes on | Brake Booster | ·
SAE Code: C136B (Case 1 and 2) ·
Output ECU: Electric brake booster (brake booster with master cylinder assembly) |
When performing the normal judgment procedure, make sure that the driver door is closed and is not opened at any time during the procedure.
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
When clearing the permanent DTCs, refer to the "CLEAR PERMANENT DTC" procedure.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off.
Turn the ignition switch to ON (READY) and turn the GTS on.
Wait for 1 second or more. [*]
[*]: Normal judgment procedure.
The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.
Enter the following menus: Chassis / Brake Booster / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE, perform driving pattern again.
| Proceed to |
|---|
| NEXT |
NEXT