If a hybrid vehicle control ECU that is incompatible with the immobiliser function is installed, the hybrid vehicle control ECU will store this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B279C95 | Engine Immobiliser System Incorrect Assembly | A hybrid vehicle control ECU that is incompatible with the immobiliser function is installed. (1-trip detection logic*) | Hybrid vehicle control ECU | - |
*: Only detected while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
|---|---|
| Hybrid control system cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B279C95 | - |
When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
The smart entry and start system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the smart entry and start system (for Start Function) after confirming that the communication systems are functioning properly.
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.
After performing repairs, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
Temporarily replace the hybrid vehicle control ECU with a new one.
| Proceed to |
|---|
| NEXT |
NEXT