RM38T0EC _58 Vehicle Interior _115230 THEFT DETERRENT / KEYLESS ENTRY _0606512 SMART ENTRY AND START SYSTEM(for Start Function, HEV Model) C

THEFT DETERRENT / KEYLESS ENTRY  SMART ENTRY AND START SYSTEM(for Start Function, HEV Model)  B277A96  Wireless Starter Component Internal Failure  


DESCRIPTION

If the remote engine start ECU does not respond to the certification ECU (smart key ECU assembly) or the remote engine start ID is not registered, this DTC is stored.

HINT:

Registration status of the remote engine start ECU ID can be checked using the "Wireless C Code" item in the Data List.


DTC No. Detection Item DTC Detection Condition Trouble Area Note
B277A96 Wireless Starter Component Internal Failure One of the following conditions is met (1 trip detection logic*):
·

A remote start communication error occurs.

·

Response is not possible.

·

Registration has not been performed.


·

CAN communication system

·

Remote engine start ECU

·

Certification ECU (smart key ECU assembly)


DTC output confirmation operation:

A remote start operation is performed.



*: Only output while a malfunction is present.


Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
Hybrid control system does not start with remote start operation Hybrid control system cannot be started by remote start operation only

Related Data List and Active Test
DTC No. Data List and Active Test
B277A96 -

CAUTION / NOTICE / HINT

NOTICE:
·

When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

·

The smart entry and start system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the smart entry and start system (for Start Function) after confirming that the communication systems are functioning properly.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>SMART ENTRY AND START SYSTEM (for Start Function, HEV Model)>HOW TO PROCEED WITH TROUBLESHOOTING

·

Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.

·

After performing repairs, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check for CAN communication system DTCs.

HINT:

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for HEV Model)>DIAGNOSIS SYSTEM


OK:

CAN communication DTCs are not output.



Result:
Proceed to
OK
NG



OK

2.REGISTER REMOTE ENGINE STARTER ID

NG

GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for HEV Model)>DIAGNOSTIC TROUBLE CODE CHART


2.REGISTER REMOTE ENGINE STARTER ID
a.

Register the remote engine starter ID.

OK:

Registration can be completed.



Result:
Proceed to
OK
NG



OK

3.CHECK REMOTE ENGINE STARTER FUNCTION

NG

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

3.CHECK REMOTE ENGINE STARTER FUNCTION
a.

Check the remote engine starter function.

OK:

Remote engine starter functions operate normally.



Result:
Proceed to
OK
NG



OK

END (REMOTE ENGINE STARTER ID WAS NOT REGISTERED)

NG

REPLACE REMOTE ENGINE START ECU