M20F-FXS, M20G-FXS STARTING  POWER SWITCH  INSPECTION  

1.885,0.969 1.885,0.292 1.885,0.292 2.198,0.292 true 1.167,1.333 0.771,1.333 true 1.438,1.75 1.438,1.344 true 1.167,0.969 0.771,0.969 true 0.104,0.094 0.417,0.25 0.313,0.156 10 false *a 2.25,0.177 2.958,0.5 0.708,0.323 10 false GND 0.479,1.25 1.01,1.5 0.531,0.25 10 false SS1 0.469,0.875 1,1.125 0.531,0.25 10 false SS2 1.323,1.75 1.854,2 0.531,0.25 10 false SS3

*a	Component without harness connected (Power Switch)

Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Switch Condition	Specified Condition
12 (SS1) - 3 (GND) 6 (SS2) - 3 (GND) 11 (SS3) - 3 (GND)	Not pushed	10 kΩ or higher
	Pushed	Below 1 Ω

If the result is not as specified, replace the power switch.

1.885,0.969 1.885,0.24 1.885,0.24 2.146,0.24 true 1.375,0.969 1.375,0.24 1.375,0.24 1.031,0.24 true 2.198,0.135 2.813,0.333 0.615,0.198 10 false GND 0.646,0.156 1.26,0.354 0.615,0.198 10 false SWIL 0.104,0.073 0.719,0.271 0.615,0.198 10 false *a

*a	Component without harness connected (Power Switch)

Apply auxiliary battery voltage between the terminals of the power switch and check the illumination condition of the power switch indicator light.

OK:

Condition	Specified Condition
Auxiliary battery positive (+) → Terminal 5 (SWIL) Auxiliary battery negative (-) → Terminal 3 (GND)	Illuminates

If the result is not as specified, replace the power switch.