The battery ECU assembly monitors its internal operation and will store these DTCs when it detects an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate | Note |
|---|---|---|---|---|---|---|
| P31B549 | Hybrid/EV Battery Internal Electronic Failure | An abnormal signal is detected by the battery ECU assembly (excessive discharging current).
(1 trip detection logic) |
Hybrid vehicle control ECU | Does not come on | Master Warning:
Comes on |
SAE Code: P31B5 |
After repairs have been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for 2 minutes or more.
Turn the ignition switch to ON and turn the GTS on.
Drive the vehicle on urban roads for approximately 10 minutes.
Enter the following menus: Powertrain / HV battery / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE, perform driving pattern again.
Check for DTCs.
| Result | Proceed to |
|---|---|
| "P31B549" only is output. | A |
| DTCs except "P31B549" of hybrid battery system are output. | B |
| DTCs except "P31B549" of hybrid control system are output. | C |
Turn the ignition switch off.
A
B
C