MALFUNCTION DESCRIPTION
The main CPU and sub CPU of the Hybrid vehicle control ECU monitor each other.
The cause of this malfunction may be the following:
Hybrid vehicle control ECU malfunction
The hybrid vehicle control ECU monitors its internal operation and will store these DTCs when it detects an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate | Note |
|---|---|---|---|---|---|---|
| P060694 | Hybrid/EV Powertrain Control Module Processor Unexpected Operation | The main CPU value received by the sub CPU of the hybrid vehicle control ECU exceeds the threshold for a certain period of time.
(1 trip detection logic) |
Hybrid vehicle control ECU | Comes on | Master Warning:
Comes on |
SAE Code:
P0606 |
The hybrid vehicle control ECU monitors its internal operation. If the internal operation is malfunctioning, the hybrid vehicle control ECU illuminates the MIL and stores a DTC.
| Related DTCs | P0606 (INF P060694): Control module processor |
| Required sensors/components | Hybrid vehicle control ECU |
| Frequency of operation | Continuous |
| Duration | TMC's intellectual property |
| MIL operation | 1 driving cycle |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not stored | TMC's intellectual property |
| Other conditions belong to TMC's intellectual property | - |
| TMC's intellectual property | - |
| Hybrid vehicle control ECU | DTC P0606 (INF P060694) is not detected |
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
When clearing the permanent DTCs, refer to the "CLEAR PERMANENT DTC" procedure.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for 2 minutes or more.
Turn the ignition switch to ON and turn the GTS on.
Turn the ignition switch to ON (READY) and wait for 10 seconds or more. [*1]
[*1]: Normal judgment procedure.
The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.
Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE, perform the normal judgment procedure again.
Check for DTCs.
| Result | Proceed to |
|---|---|
| P060694 only is output. | A |
| DTCs except P060694 are output. | B |
Turn the ignition switch off.
A
B