PB10 HYBRID TRANSMISSION / TRANSAXLE  COMBINATION SWITCH  INSPECTION  

0.719,1.927 1.302,1.927 1.302,1.927 1.802,1.51 true 2.688,1.927 2.521,1.927 2.521,1.927 2.021,1.51 true 0.063,0.042 0.375,0.198 0.313,0.156 10 false *a 2.729,1.844 2.979,2.094 0.25,0.25 10 false E 0.406,1.833 0.844,2.073 0.438,0.24 10 false DRV

*a	Component without harness connected (Drive Mode Select Switch (Combination Switch Assembly))

Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
6 (DRV) - 5 (E)	Drive mode select switch (combination switch assembly) being pushed and held	Below 1 Ω
	Drive mode select switch (combination switch assembly) not pushed	10 kΩ or higher

0.708,0.292 0.979,0.292 0.979,0.292 1.396,1.125 true 2.698,0.292 2.448,0.292 2.448,0.292 2.031,1.125 true 0.042,0.042 0.354,0.198 0.313,0.156 10 false *a 0.365,0.208 0.979,0.406 0.615,0.198 10 false ILL+ 2.792,0.219 3.406,0.417 0.615,0.198 10 false ILL-

*a	Component without harness connected (Drive Mode Select Switch (Combination Switch Assembly))

Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the drive mode select switch (combination switch assembly).

Standard:

Measurement Condition	Specified Condition
Auxiliary battery positive (+) → 4 (ILL+) Auxiliary battery negative (-) → 1 (ILL-)	Illuminates