INSPECT ILLUMINATED ENTRY SYSTEM OPERATION
Perform this inspection with the customize parameters at the initial settings.
Perform this inspection with the map light assembly door linked switch on and the room light assembly switch set to DOOR.
| Control | Condition | Lights that Operate |
|---|---|---|
| Actuation Area-linked*1 | With the push start switch off and all of the doors closed and locked, enter an exterior detection area while carrying an electrical key transmitter and check that the lights that operate turn on for approximately 15 seconds and then turn off. | ·
Map Light Assembly ·
No. 1 room light assembly ·
Front Door Ambient Illumination Light (Front Door Trim Board Sub-assembly)*3 ·
Center tray illumination light (No. 1 interior illumination light assembly)*3 ·
Cup holder light (Console box pocket garnish)*3 |
| Door Lock/Unlock-linked | With the ignition switch off and all of the doors closed and locked, unlock any door using an unlock operation (key-linked, wireless or entry unlock operation) and check that the lights that operate turn on for 15 seconds and then turn off. | ·
Map Light Assembly ·
No. 1 room light assembly ·
Front Door Ambient Illumination Light (Front Door Trim Board Sub-assembly)*3 ·
Center tray illumination light (No. 1 interior illumination light assembly)*3 ·
Cup holder light (Console box pocket garnish)*3 |
| Door Open/Close-linked | With the ignition switch off and all of the doors closed, open any door and check that the lights that operate turn on. While the lights that operate are on, close all of the doors and check that the lights that operate turn off after approximately 15 seconds. | ·
Map Light Assembly ·
No. 1 room light assembly ·
Front Door Ambient Illumination Light (Front Door Trim Board Sub-assembly)*3 ·
Center tray illumination light (No. 1 interior illumination light assembly)*3 ·
Cup holder light (Console box pocket garnish)*3 |
| With the push start switch off and all of the doors closed, open any front door and check that the light that operates turns on. While the light that operates is on, close the front doors and check that the light that operates turns off after approximately 40 seconds. | Push Start Switch Illumination*1 | |
| With the ignition switch in ON, open any door and check that the lights that operate turn on. While the lights that operate are on, close all of the doors and check that the lights that operate turn off. | ·
Map Light Assembly ·
No. 1 room light assembly |
|
| Push Start Switch Illumination*1 | Turn the ignition switch from ACC or ON to off and check that the lights that operate turn on for approximately 15 seconds and then turn off. | ·
Map Light Assembly ·
No. 1 room light assembly ·
Front Door Ambient Illumination Light (Front Door Trim Board Sub-assembly)*3 ·
Center tray illumination light (No. 1 interior illumination light assembly)*3 ·
Cup holder light (Console box pocket garnish)*3 |
| Turn the ignition switch from ACC or ON to off and check that the light that operates turns on for approximately 40 seconds and then turns off. | Push Start Switch Illumination | |
| Push Start Switch-linked*1 | Turn the ignition switch from ACC or ON to off and check that the lights that operate turn on for approximately 15 seconds and then turn off. | ·
Map Light Assembly ·
No. 1 room light assembly ·
Front Door Ambient Illumination Light (Front Door Trim Board Sub-assembly)*3 ·
Center tray illumination light (No. 1 interior illumination light assembly)*3 ·
Cup holder light (Console box pocket garnish)*3 |
| Turn the ignition switch from ACC or ON to off and check that the light that operates turns on for approximately 40 seconds and then turns off. | Push Start Switch Illumination*1 | |
| Ignition Switch-linked*2 | Turn the ignition switch from ACC or ON to off and check that the lights that operate turn on for approximately 15 seconds and then turn off. | ·
Map Light Assembly ·
No. 1 room light assembly |
*1: w/ Smart Entry and Start System
*2: w/o Smart Entry and Start System
*3: w/ Ambient Illumination Light
INSPECT AUXILIARY BATTERY SAVING CONTROL OPERATION
The operations and conditions of this control are described below.
| Control | Condition | Lights that Operate |
|---|---|---|
| Basic Operation | When 20 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off.
|
·
Map Light Assembly ·
No. 1 room light assembly ·
No. 1 Luggage Compartment Light Assembly ·
Front Door Ambient Illumination Light (Front Door Trim Board Sub-assembly)*2 ·
Center tray illumination light (No. 1 interior illumination light assembly)*2 ·
Cup holder light (Console box pocket garnish)*2 |
When 20 minutes elapse after the driver door/front passenger door is opened and the lights that operate remain on, the lights are turned off.
|
Push Start Switch Illumination*1 |
*1: w/ Smart Entry and Start System
*2: w/ Ambient Illumination Light