DOOR / HATCH  POWER BACK DOOR SYSTEM  INITIALIZATION  

INITIALIZE MULTIPLEX NETWORK DOOR ECU

NOTICE:

Initialization of the multiplex network door ECU (back door initial position learning) is necessary if the following work procedures are performed while the back door is open.

·

The cable to the negative (-) auxiliary battery terminal is connected.

·

A power source system fuse of the power back door system is disconnected and reconnected.

·

The multiplex network door ECU is replaced or the connectors are disconnected.

·

The power back door unit assembly set LH or power back door unit assembly set RH is removed and reinstalled, or replaced.

The power back door does not operate unless the multiplex network door ECU is initialized.

HINT:

·

Initialization is not necessary if the above procedures are performed while the back door is closed.

·

When disconnecting the negative (-) auxiliary battery terminal, some systems need to be initialized after the negative (-) auxiliary battery terminal is reconnected.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART202201,202307,_V1,_106911,_0485800,RM100000001XG8R,202307,999999,_V1,_106911,_0485800,RM100000002CEKZ,